11Section 3 — ASSembly & Set-Up
2. Position the seat assembly in place over the holes, as
shown in Figure 3-5.
Figure 3-5
3. Secure the seat assembly with the self-tapping bolts
previously removed.
CAUTION: Do not use any type of power tool (e.g.
impact gun or electric drill with nut driver attached)
when tightening the self-tapping bolts to attach the
seat bracket.
4. To adjust the position of the seat, remove the adjustment
bolt on the bottom of the seat. Slide the seat forward or
backward as desired. Reinstall the adjustment bolt. Refer to
Figure 3-5.
7. Slide the Pedestal cap down onto the tractor (1) and slighty
rotate to the right to clip into place. Secure the pedestal
with the pan head screw (2) previously removed. See Figure
3-3.
Figure 3-3
Attaching The Seat
If the seat for your tractor was not attached at the factory, follow
the applicable instructions below to attach it.
1. Using a /-inch drive ratchet with a /” socket, remove the
two self-tapping bolts factory installed on the tractor. See
Figure 3-4.
Figure 3-4
11
To Next Page
Loading...
