Assembly & Set-Up
3
10
4. Lower the steering wheel assembly onto the lower steering
shaft and secure with the shoulder bolt and lock nut
previously removed. See Figure 3-2.
Figure 3-2
5. Tighten the shoulder bolt and lock nut using a 9/16”
wrench and 7/16”wrench or socket.
6. Remove the pedestal cap mount pan head screw factory
installed and located on the tractor’s steering console.
Retain the screw for later instructions.
Installing The Steering Wheel Assembly
If the steering wheel assembly for your tractor did not come
already installed, follow the steps below:
1. Slide the pedestal cap onto the steering shaft so that when
the steering shaft is installed on the tractor, the pedestal
cap will be upright as shown in Figure 3-1.
Figure 3-1
2. Remove the shoulder bolt and lock nut from the steering
shaft and retain for later steps.
3. With the steering wheel assembly upright and positioned
over the lower steering shaft on the tractor, align the
steering wheel so that with the tractor wheels straight, the
large opening on the steering wheel is facing forward.
Contents of Crate
• One Riding Mower • One Engine Operator’s Manual • One Hardware Pack
• One Steering Wheel/Shaft Assembly • One Seat Assembly • One Product Registration Card
• One Operator’s Manual • One Steering Pedestal Cap
Assembly & Set-Up
3
10
To Next Page
Loading...
