9
G
z Always wait for the cutting tool is stop.
z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original cord spools
and note the installation instructions!
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed
service centres or by the manufacturer.
z Make sure all air holes are free of dirt.
z Do not store the unit within reach of children.
Disposal
Assembly
Attach the protective cover
1. Place the protective cover on the lawn trimmer
.
2. Attach the protective cover with the fastener
screws .
3 Before starting the trimmer, remove the
cut protector on the thread measurer .
Assembly of the lawn trimmer
3 Note:
The lawn trimmer can be used for free cut-
ting and edge cutting (for more infor-
mation, see the Chapter “Working Position”
Page 10).
z Plug the upper portion of the lawn trimmer into
the lower portion. The connection snaps audi-
bly .
3 Disassembly of the lawn trimmer
In order to be able to change the working
position, one can loosen the upper and low-
er sections of the lawn trimmer.
z Typ A: Press both locks of the upper sec-
tion together and pull both sections
apart .
z Typ B: Press the locks for the telescop-
ing section in the direction of the arrows
and pull both sections apart .
Operation
Operating times
z Please check noise abatement regulations
prevailing in your country.
Set the grip height (Typ B)
1. Loosen the hand wheel .
2. Pull the telescoping section until the ideal grip
height is achieved .
3. Turn the hand wheel .
Insert power cable into cable holder
The power cable holder in the guide grip prevents
accidental disconnection of the extension cable
.
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equipment, accessories and packag-
ing in an environment-friendly man-
ner.
To Next Page
Loading...
