MTD 710, 700 - User Manual

Questions and Answers

K
kimberlycainJul 31, 2025
Why MTD 710, 700 Trimmer engine will not start?
- D
  Derek GardnerJul 31, 2025
  If your MTD Trimmer engine won't start, it might be due to several reasons. First, ensure the fuel tank isn't empty and is filled with properly mixed fuel. If the tank has fuel, try pressing the primer bulb fully and slowly 10 times. If the engine is flooded, squeeze the trigger and pull the starter rope with the choke in Position 3. Old or improperly mixed fuel can also be a culprit, so drain the tank and add a fresh fuel mixture. Lastly, a fouled spark plug can prevent starting, so replace or clean it.
A
ayerscindyAug 6, 2025
What to do if MTD 710, 700 Trimmer engine lacks power or stalls?
- A
  Ariel ElliottAug 6, 2025
  If your MTD Trimmer engine lacks power or stalls, the issue could stem from a few common causes. Old or improperly mixed fuel is a frequent culprit; drain the fuel tank and add a fresh fuel mixture. Another potential cause is improper carburetor adjustment, which requires taking the trimmer to an authorized service dealer for adjustment. Lastly, a fouled spark plug can lead to power loss, so try replacing or cleaning the spark plug.
K
Krista MillerAug 14, 2025
How to fix MTD Trimmer engine that will not accelerate?
- C
  Chad NelsonAug 14, 2025
  If your MTD Trimmer engine won't accelerate, several factors could be responsible. Start by checking the fuel; old or improperly mixed fuel can hinder acceleration, so drain the tank and add a fresh fuel mixture. A dirty air filter can also cause this issue, so clean or replace it. If the cutting attachment is bound with grass, stop the engine and clean the cutting attachment. For improper carburetor adjustments, take the trimmer to an authorized service dealer.
J
Jeffery BowersAug 22, 2025
What to do if MTD 710, 700 cutting attachment will not advance?
- J
  Jacob ShafferAug 22, 2025
  If the cutting attachment on your MTD Trimmer will not advance, there are several potential causes. First, if the cutting attachment is bound with grass, stop the engine and clean the cutting attachment. If the cutting attachment is out of line, refill it with a new line. An inner reel that is bound up requires rewinding or replacing. A dirty cutting head needs cleaning of the inner reel and outer spool. If the line is welded, disassemble, remove the welded section, and rewind. If the line is twisted when refilled, disassemble and rewind the line. Finally, if not enough line is exposed, push the bump knob and pull out line until 4 inches (102 mm) of line is outside of the cutting attachment.