69
INSTALLING THE CHARGING STATION
Find a location with access to power, ensuring the
mower can leave the charging station in an anti-
clockwise direction. Don“t peg the plate down yet.
The location of the charging station should be flat
and secure, without risk of movement, if placed
next to a border edge that is unstable it can slump
and cause the station to be uneven, this will cause
problems for the mower when returning to
charge.
WARNING: Trailing wires are a trip hazard. Take care when choosing your location.
The boundary wire goes into the
front (1) of the charging station
and comes out at the back (2).
Push the boundary wire into the
tube at the front (1) of the
charging station.
It will emerge at the rear of the
unit (2).
To Next Page
Loading...
