What to do if the green light on the MTHTrains dcs remote commander receiver isn't flashing?
If the green light on the receiver isn't flashing when you press a button on the handheld remote, try replacing the batteries in the remote with two new AA batteries. Ensure the remote is pointing towards the receiver base within 20 feet. Also, remove the red lens and check that the IR receiver is centered.
Why is there no sound on my MTHTrains Toy engine?
If your engine has no sound, first ensure that the SU/SD button has been pressed. If it still has no sound, press the VOL button and then press the + button on the throttle control to increase the volume.
What to do if the MTHTrains dcs remote commander engine volume isn't adjusting?
If the engine volume is not adjusting when you press the throttle control, press the VOL button and then press the + or - button on the throttle control within 2 seconds to raise or lower the engine volume.
What to do if my MTHTrains dcs remote commander Toy engine does nothing when Start-Up is pressed?
If the engine does nothing when the Start-Up button is pressed, the engine address must be set to the factory default. Reset the engine to factory defaults using either a DCS System or a DCS Commander.
How to fire the coupler on MTHTrains dcs remote commander Toy engine?
First, make sure your model has coil-wound proto-couplers. To fire the coupler, press the CPLR button, then press + or - on the throttle control within 2 seconds to fire the front (+) or rear (-) coupler.
Why are idle sounds not playing on my MTHTrains dcs remote commander when I press the SND button?
Idle sounds will only play when the engine is standing still. Ensure the engine is not moving when you press the SND button.
How to cycle through PFA sequences on MTHTrains dcs remote commander engine?
To cycle through all four PFA sequences, press the DIR button.
General| Brand | MTH Trains |
|---|---|
| Model | DCS Remote Commander |
| Category | Toy |
| Display Type | LCD |
| Compatibility | MTH DCS-equipped trains |
| Power Source | Batteries |
| Type | Remote Control |
Instructions for installing the DCS Remote Commander and connecting power for O-Gauge.
Details the functions of each button on the DCS Remote Commander handheld unit.
How to play freight yard or passenger station sound sequences on PS2/PS3 equipped engines.
Explanation of how to use the remote uncoupling action for Proto-Couplers.
Instructions to fire the rear coupler using the remote control.
Instructions to fire the front coupler using the remote control.
Details the speed control capabilities of M.T.H. Proto-Sound 2.0 and 3.0 engines.
Procedure to reset engines to factory default settings for DCS Remote Commander compatibility.
Describes automatic sound effects played by PS2 or PS3 equipped engines.
Steps to follow for obtaining warranty service for M.T.H. products.
Details of the one-year limited warranty coverage for M.T.H. products.
To Next Page
