To Next PageTo Next Page
Need help?Do you have a question about the MTL MTL5061 and is the answer not in the manual?
General| Brand | MTL |
|---|---|
| Model | MTL5061 |
| Category | Recording Equipment |
| Language | English |
Covers DIN rail mounting, wiring connections, conductor preparation, and crimp ferrule selection for MTL5000 isolators.
Instructions for installing and using MTL5000 Series power bus kits for linking multiple units to a 24V power supply.
Describes the MTL5011 for safe-area load control by hazardous-area switches, including wiring and phase reversal.
Covers the MTL5011B, similar to MTL5011, with added line fault detection, wiring, and testing.
Details the MTL5012 for solid-state output control, including LFD, wiring connections, and testing procedures.
Explains the MTL5014 for relay control of two loads, featuring phase reversal, LFD, and wiring configurations.
Details the MTL5015 for controlling two loads via solid-state output, including LFD, phase reversal, and wiring.
Describes the MTL5016 for relay control of two loads by two switches, featuring phase reversal and testing.
Covers the MTL5017, similar to MTL5018, with added line fault detection, wiring, and testing.
Details the MTL5018 for dual-channel relay control, featuring LFD, phase reversal, wiring, and testing.
Describes the MTL5018AC for dual-channel relay control, featuring LFD, phase reversal, wiring, and testing.
Details the MTL5021 for controlling hazardous-area devices with a safe-area switch, including wiring and testing.
Explains the MTL5022 for controlling hazardous-area devices, suitable for IIA/IIB applications, with wiring and testing.
Covers the MTL5023 for controlling devices via volt-free contact or logic signal, featuring LFD, phase reversal, wiring, and testing.
Guidelines for periodically checking the condition of isolator installations, connections, and general integrity.
