Need help?Do you have a question about the MTS Systems 318.25 and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Dynamic Force Rating | 25 kN |
| Frequency Range | Varies depending on configuration, typically up to 100 Hz |
| Control Modes | Strain |
| Model | MTS Systems 318.25 |
Information on contacting MTS for technical assistance via web, email, or phone.
Information required by MTS to efficiently assist users with technical issues.
Diagram and list identifying the main components of the 318 Load Unit.
Technical specifications including general parameters, load ratings, and mounting threads.
General safety information pertaining to servohydraulic systems, intended use, and hazards.
Essential safety practices to follow before applying hydraulic power to the test system.
Safety precautions to ensure during the operation of the test system.
Procedure for unpacking and preparing the load unit when installed in an upright configuration.
Procedure for unpacking and preparing the load unit when installed in a horizontal configuration.
Description of controls on the load unit's control module for grips and crosshead.
Identification of crush points during operation and necessary precautions.
Table listing recommended intervals for various maintenance procedures for the 318 Load Unit.
Procedure for aligning the force transducer with the actuator for accurate measurements.
To Next Page
