Need help?Do you have a question about the mtts Light Meter and is the answer not in the manual?
General| Brand | mtts |
|---|---|
| Model | Light Meter |
| Category | Measuring Instruments |
| Language | English |
Defines warning statements related to potential injury.
Defines note statements for additional information.
Manual is for healthcare professionals, requires qualified personnel.
The MTTS Light Meter is single measurement unit suitable for overhead and bed type phototherapy. It has 2 sensors loc on both sides of the meter.
ON/OFF button is the 'touch type'. Place the finger on the touch panel, do not press hard.
Measures irradiance of neonatal phototherapy lights (440-465nm).
Defines units like microwatts per cm²/nm and nanometer.
Shows response characteristics matching bilirubin spectrum.
Explosion hazard, flammables, reading manual, practitioner supervision, pre-use inspection.
Facility responsibility for personnel training and record keeping.
Instructions for taking measurements with overhead phototherapy.
Reading measurement and adjusting aim for maximum reading.
Procedure to turn off the device and auto-shutoff.
Guidance for taking separate measurements for multiple lights.
Steps to turn on the device.
Placement instructions for Bili-Bed measurements.
Reading measurement and adjusting aim for maximum reading.
Averaging multiple readings for Bili-Bed.
Turning off the device and auto-shutoff.
Handling combined readings from multiple light sources.
Indicates low battery status and action required.
Lists necessary items for cleaning.
Steps for cleaning the device, using damp cloth and detergent.
Maintenance and service must be performed by qualified technicians.
Warning about static sensitive PCBs and necessary ESD protection.
Lists required batteries for replacement.
Steps for battery replacement: removing cover, inserting batteries.
Factory calibration details and NIST compliance.
Recalibration required every 36 months at MTTS.
Recommends returning both readout and sensor for calibration.
No customer serviceable parts; return for repair/parts.
Recalibration after service is necessary for accuracy.
Warning about servicing affecting warranty and causing damage.
Steps to initiate service: contact MTTS for RMA number.
Preparation for shipping: cleaning, packaging, RMA.
Shipping address for equipment in Asia.
Key performance metrics: wavelength, range, accuracy.
Details about the device display and indicators.
Physical attributes: dimensions and weight.
Power source and operational duration.
Environmental conditions for operation and storage.
Lists any exclusions for specifications.
Lists relevant industry standards: ISO, IEC.
Symbol indicating need to refer to the User Manual.
Symbol for prohibition of disassembly by untrained personnel.
Symbol indicating avoidance of direct sunlight.
Symbol for proper waste disposal and recycling.
Symbols for device manufacturer, date, and serial number.
Symbols for power specifications, CE marking, and EC REP.
Outlines general terms and conditions of the limited warranty.
Discusses warranty applicability across countries.
Details MTTS's sole discretion in repair/replacement.
Lists items and conditions not covered by the warranty.
States limitations on MTTS's liability for damages.
Defines the duration of the limited warranty.
Outlines customer duties for warranty support.
Provides instructions on how to contact MTTS for support.
To Next Page