Why is lube oil pressure too low (limit value 2) in MTU Engine?
If the lube oil pressure is too low (limit value 2) in your MTU Engine, it could be due to insufficient oil. Check the oil level and top up as necessary. You can also acknowledge the alarm and restart the engine. If the problem persists, contact Service.
Why is exhaust temperature (A-side) too high (limit value 1) in MTU 12 V 4000 T94 Engine?
If the exhaust temperature (A-side) is too high (limit value 1) in your MTU Engine, it could be due to cable damage. Check the air filter and wiring. If the problem persists, contact Service.
What causes white exhaust gas from MTU 12 V 4000 T94?
White exhaust gas from your MTU Engine can be caused by a few things. The engine might not be at operating temperature, so run it up to operating temperature. There could also be water in the fuel, so check the fuel system on the fuel prefilter and drain the fuel prefilter if leaking. If the problem persists, contact Service, as the engine may be defective.
General| Engine Type | Diesel |
|---|---|
| Model | 12 V 4000 T94 |
| Number of Cylinders | 12 |
| Cylinder Configuration | V |
| Configuration | V |
| Displacement | 57.2 liters |
| Bore | 170 mm |
| Aspiration | Turbocharged |
| Cooling System | Water-cooled |
| Emissions Compliance | IMO Tier II |
Precautions before starting and during operation of the engine.
Warning and safety instructions regarding explosion hazard due to oil vapors.
General safety rules for maintenance and repair activities.
Safety guidelines for materials, fluids, lubricants, fire prevention, and disposal.
Detailed technical specifications and reference conditions for the engine models.
Procedures for restarting an engine after a long period of inactivity.
Routine checks to be performed during engine operation for safety and performance.
Step-by-step guide for starting the engine manually.
Procedures for safely stopping the engine in manual mode.
A table referencing maintenance tasks and their corresponding pages in the schedule.
General troubleshooting guide for common engine issues and symptoms.
Explanation of fault codes displayed on the SAM system.
Details specific fault messages from the ECU and their corrective actions.
Procedures related to engine handling and basic operations.
Instructions for endoscopic examination of cylinder liners.
To Next Page