Oil filter replacement with the
engine stopped
1. Stop engine (→ Page 57) and disable engine
start.
2. Cut out the filter to be replaced.
A Right filter cut out
B Both filters cut in (normal operating
position)
C Left filter is cut out.
3. Use oil filter wrench to unscrew cut-out oil fil-
ter.
4. Clean the sealing surface on the connecting
piece.
5. Check condition of the new sealing ring and
coat it with oil.
6. Fit SOLAS shield (→ Page 91).
7. Screw on and tighten new oil filter by hand.
8. Replace other oil filters in the same way.
9. Switch filter to normal position.
10. After each oil change and filter replacement,
crank engine with starting system
(→ Page 99).
11. Check oil level (→ Page 134).
Oil filter replacement with the engine running
1. Reduce engine speed to <1100 rpm.
2. Use oil filter wrench to unscrew cut-out oil filter.
3. Clean the sealing surface on the connecting piece.
4. Check condition of the new sealing ring and coat it with oil.
5. Fit SOLAS shield (→ Page 91).
6. Screw on and tighten new oil filter by hand.
7. Replace other oil filters in the same way.
8. Switch filter to normal position.
9. Check oil level (→ Page 134).
M015650/06E 2018-05
| Oil Filtration / Cooling | 137
TIM-ID: 0000006365 - 009
To Next Page
Loading...
