• Setting For Full Range (No Crossover): To disable the electronic crossover, select the “OFF” position of
the X-OVER switch. This setting will allow the amplifier to play all frequencies.
4. Remote Subwoofer Level Control (Remote Sub) – Lets say the amplifiers gain is set at half way, when
the remote subwoofer level control is plugged in, you now have external control of the gain from zero – half
way. The installation of this level control is NOT necessary to get full power from amplifier.
5. Prizm EFX – Now that you have completed adjusting all your amplifier settings, you can set the lighting
effects to you personal taste.
• Selecting Colors: You can change the backlit colors simply by turning the Pot labeled PRIZM COLOR
located in the MTX PRIZM EFX section of the control panel left or right. Starting at the most counter
clockwise position, the colors range from RED, GREEN, BLUE, and RED again or any color in between
making the combination unlimited.
• Selecting The EFX Feature: You can switch Prizm EFX lighting to “pulsate” with beat of music. Simply
depress the button labeled PRIZM EFX located in the in the MTX PRIZM EFX section of the control panel to
turn this feature on or off.
Trouble Shooting
Read this if you want to be a do-it-yourselfer or give us a call at 800-CALLMTX.
PROBLEM CAUSE SOLUTION
No LED indication No +12V at remote connection Supply +12V to terminal
No +12V at Power connection Supply +12V to terminal
Insufficient ground connection Verify ground connection
Blown power fuse Replace fuse
LED on, no output Volume on head unit off Increase volume on head unit
Speaker connections not made Make speaker connections
Gain control on amplifier off Turn up gain
Signal processing units off Apply power to signal processor
All speakers blown Replace speakers
Output distorted Head unit volume set too high Lower head unit volume
Amplifier gain set too high Lower amplifier gain
Balance reversed Speakers wired L + R reversed Wire speakers with correct orientation
RCA inputs reversed Reverse RCA input
Bass is weak Speakers wired out Wire with correct of phase
phase
Not using MTX woofers Buy MTX woofers
Blowing fuses Excessive output levels Lower volume
Amplifier defective Return for service
To Previous Page
Loading...
