Need help?Do you have a question about the MTX Thunder X704 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| RMS Power at 4 Ohms | 70 Watts x 4 Channels |
| RMS Power at 2 Ohms | 100W x 4 |
| Bridged RMS Power at 4 Ohms | 200 Watts x 2 Channels |
| Crossover | Variable Low-Pass/High-Pass |
Main power input. Connect directly to the positive battery terminal using 16mm2 wire.
Connect to chassis for peak performance. Use short, heavy gauge cable.
Disconnect the vehicle's negative battery connection before starting installation.
Run positive power cable through firewall using a grommet. Connect to +BATT terminal.
Install breaker/fuse near battery. Connect power cable to positive battery terminal.
Attach ground wire to bare metal on vehicle chassis and GND terminal.
Double-check all connections, reconnect battery, and turn on circuit breaker.
To Next Page