Need help?Do you have a question about the MTX X3000D and is the answer not in the manual?
General| Brand | MTX |
|---|---|
| Model | X3000D |
| Category | Car Amplifier |
| Language | English |
Thank you for choosing an MTX X THUNDER Amplifier. Explains CEA2006 certification.
Lists technical ratings for the MTX X3000D amplifier.
RCA input jacks for source units with RCA or Line level outputs. Minimum 250mV level required.
Master out connection for two MTX X3000D amps in a 'strapped' configuration.
Slave in connection for two MTX X3000D amps in a 'strapped' connection.
Allows operation from source units with speaker-level outputs.
Selects high pass subsonic filter frequency to protect subwoofer(s).
Matches amplifier input sensitivity to the source unit.
Selects desired low pass x-over frequency between 40Hz and 200Hz.
Matches amplifier input to source unit or DSP unit output.
Selects output signal phase (0° or 180°).
Connects the included Electronic Bass Control for remote bass adjustment.
Connects speakers ensuring correct polarity for optimal sound quality.
Main power input, must connect directly to the car battery positive terminal.
Turns amplifier on by applying 12 volts, usually from source unit's remote lead.
Connects amplifier ground to the vehicle chassis for peak performance.
Step-by-step guide for mounting the amplifier and connecting wiring.
Procedure for setting the amplifier's gain control to prevent distortion.
Instructions for connecting two amplifiers in Master/Slave mode for increased power.
To Next Page