Need help?Do you have a question about the MTX XTHUNDER X500D and is the answer not in the manual?
General| Power Output (RMS) | 500W |
|---|---|
| Channels | 1 |
| THD at Rated RMS Power | <1% |
| Bass Boost Frequency | 45 Hz |
| Operating Voltage | 10V - 16V |
| RMS Power at 2 Ohms | 500W x 1 |
| Bass Boost | 0-18dB |
| Fuse Rating | 30A |
Disconnect the vehicle's negative battery connection before starting installation.
Choose a location with sufficient airflow for cooling. Mark and drill holes.
Run positive power cable through firewall using grommet. Connect to +BATT terminal.
Install breaker/fuse within 30cm of battery for safety. Ensure it is off/removed.
Attach ground wire to bare metal chassis contact point and amplifier GND terminal.
Connect to source unit's remote or power antenna lead.
Connect RCA cables or speaker wires from source unit to amplifier inputs.
Double-check all connections, reconnect battery, turn on circuit breaker/fuse.
To Next Page
