Беларус 1220.1/1220.3 Раздел Х. Хранение трактора
Х2
tive composition or wrap around with in-
sulating material (such as waxed paper,
polyethylene film, etc.).
To ensure free exit of water and con-
densate from the cooling system, leave
the drain devices open. Close the hoods
and the cab doors.
When performing maintenance of the
machines during storage, check correct
installation of the machines on supports
or pads (no warps), completeness, tire
pressure, reliable sealing, condition of
corrosion-resistant coatings (availability of
protective grease, integrity of paint, no
corrosion), condition of protective devices
(integrity and strength of safety enclo-
sures, covers). Eliminate all found faults.
Maintenance of the tractor when re-
moving it from storage involves taking the
tractor off the supports, cleaning, and if
necessary depreservation of the tractor,
components, removal of sealing devices,
installation of removed parts, tools to the
tractor, checking operation and adjusting
the tractor and its parts.
Requirements to inter-shift storage
of machines
The tractor can be stored on yards and
places of inter-shift storage or directly on
the place of works. Tightly close with
cover all holes, through which precipita-
tion can ingress internal cavities of the
tractor. The storage batteries must be
disconnected..
Requirements to short-time storage
of machines
Install the tractor for storage com-
plete without removing tractor units and
assemblies.
Disconnect the storage battery. The
electrolyte level and density must con-
form to the recommendations for main-
tenance and servicing of storage batte-
ries. When storing tractors at low temper-
atures, or during more than one month,
remove the batteries and sent to ware-
house.
Requirements to long-time storage of
machines on open yards
Preparing the engine for long-time sto-
rage includes preservation of the surfaces
of parts located inside the engine (internal
preservation) and flushing the cooling sys-
tem, sealing the inner surfaces, preserva-
tion of exterior unpainted surfaces of the
engine (exterior preservation), packing the
engine into an enclosure polymer film
when no hood is available. When there is
no fuel in the fuel tanks, preservation
must be done with use of volatile inhibi-
tors. Clean and rinse the air cleaner, fill
operating preservation oil to the tray.
Clean and lubricate threaded connec-
tions of the hitch mechanism, hydraulic
systems, steering linkages, etc.
Preservation
Temporary corrosion protection of trac-
tor units and systems from environmental
impact during transportation and storage
of the tractor is provided by preservation.
Clean all tractor surfaces to preserve of
mechanical impurities, degrease and dry.
Preservation is made to unpainted inte-
rior and exterior surfaces with galvanized
coating, viewed units of the tractor and in
the cab by applying rust-preventive oil
RUST BAN 397. SUMIDERA 397. Ma-
terial consumption is 0.02 to 0.03 kg per
tractor.
Preservation of inner surfaces of the
engine is carried out after running in the
tractor by filling rust-preventive additive
PFINDER AR 241. CORTEK VCI 329
through the coarse filter to fill cavities with
preservation composition. Material con-
sumption is 0.05 kg per tractor.
Preservation of the fuel tank internal
surfaces is carried out by spraying after
their manufacture prior to painting rust-
preventive oil RUST BAN 335. ML -5888,
instrument panel — after assembling —
by spraying to the inner surfaces of the
panel of rust-protective oil RUST BAN
397, SUMIDERA 397. The PTO shaft
ends are preserved by lubricating with
rust-protective oil RUST BAN 335, ML -
To Next Page
Loading...
