External chain couplings (2)
Partial locking
Ensure the horizontal displacement of the
machine under working condition by con-
necting restricting chains to the bottom
apertures of the holder (1) and adjusting
the chain length using tie bars (2) to ob-
tain the implement swinging of at least
125 mm in each direction or in accord-
ance with the operating manual for the
machine.
When operating the ploughs, adjust the
length of the right angle brace to the tilling
depth.
ATTENTION! When lifting the machine
to the transport position, keep obligatori-
ly the swinging of the machine to at
least 125 mm to prevent the chain from
breakdown.
When putting the machine to the transport
position, strain the chains by using the tie
bars (2). Swinging of not more than 20 mm
in each direction is allowed.
Full locking
To lock the machine fully in the working
position, attach the restricting chains (20
to the second from bottom aperture of
holder (1) and reduce the chain (2) length
to the maximum extent.
In the transport position the locking is en-
sured automatically.
To Next Page
Loading...
