the slot in the nut is aligned with the cutter
pin hole and fix it by means of the cotter
pin.
4. The power rod shall be adjusted after
adjustment of the power sensor:
а) Set the switch (1) to the middle position
(see Fig. 28);
b) Using an additional lever, apply a force
ensuring the turn of the shackle to the ex-
treme position (in the direction of the ar-
row "А");
c) While holding the lever in the released
position (in the direction of the arrow "А"),
check the possibility of entering of the pro-
jection of the switch (1) to the slot of the
power lever (3). If it is impossible, adjust
the length of the rod (5) so that the projec-
tion of the switch (1) would enter freely the
slot of the power lever (3);
d) Shorten the rod (5) by 1 turn of the ad-
justing nuts (6).
With the agricultural implement mounted
on the tractor no use of a special addition-
al lever for adjusting the power rod is re-
quired. In this case, it is sufficient to lift
slightly the implement above the surface
of the ground, on which the tractor stays,
then the weight of the implement would
create a necessary stretching force ap-
plied to the power sensor through the cen-
tral rod. It should be noted that the central
rod shall be set to the upper hole of the
shackle of the mounted attachment. The
implement should be lifted just until it is
taken off the ground.
To Next Page
Loading...
