Do you have a question about the MUGEN MBX-6 and is the answer not in the manual?
Scale | 1/8 |
---|---|
Fuel Type | Nitro |
Drivetrain | 4WD |
Drive | Shaft |
Chassis | 7075 Aluminum |
Shock Type | Oil Filled |
Differential | 3 Gear |
Body | Not included |
Key specifications like width, wheelbase, gear ratio, and weight.
List of external parts and accessories required to complete the kit.
List of tools necessary for assembling the RC car kit.
Visual guide showing the actual sizes of screws included in the kit.
Instructions for assembling the front and rear differentials.
Instructions for assembling the center differential.
Further instructions for assembling the center differential.
Instructions for assembling the center shaft.
Instructions for assembling the front gear case.
Additional steps for assembling the front gear case.
Instructions for assembling the rear gear case.
Instructions for assembling the front lower arm.
Steps for attaching the front lower arm to the chassis.
Steps for installing the front anti-roll bar.
Instructions for assembling the front upper plate.
Steps for installing the front upper arm.
Instructions for assembling the front upright.
Steps for attaching the front upright.
Instructions for assembling the servo saver.
Steps for installing the servo saver.
Steps for installing the rear damper stay.
Instructions for assembling the rear lower arm.
Steps for installing the rear lower arm.
Steps for installing the rear anti-roll bar.
Instructions for assembling the rear upper arm.
Steps for installing the rear upper arm.
Instructions for assembling the rear upright.
Steps for installing the rear upright.
Steps for installing the rear mud guard.
Instructions for assembling the center differential mount.
Steps for installing the stone guard.
Steps for installing the front unit.
Steps for installing the center differential mount.
Steps for installing the rear unit.
Instructions for assembling the tie-rods.
Steps for installing the tie-rods.
Instructions for assembling the servo.
Steps for installing the switch.
Instructions for assembling the radio box.
Steps for installing the radio plate.
Instructions for assembling the steering rods.
Steps for installing the fuel tank.
Instructions for assembling the clutch.
Steps for installing the engine.
Steps for installing the muffler guard.
Steps for installing the muffler.
Instructions for assembling the engine control linkage.
Adjusting linkage for neutral, full throttle, and brake settings.
Instructions for assembling the front dampers.
Instructions for assembling the rear dampers.
Steps for installing the front dampers.
Steps for installing the rear dampers.
Instructions for assembling the wing stay.
Steps for installing the wing.
Instructions for assembling the air filter.
Steps for installing the air filter.
Steps for installing the fuel and pressure pipes.
Steps for installing the tires onto the wheels.
Instructions for cutting and preparing the car body.
Steps for mounting the body onto the chassis.
Procedure for turning on the radio transmitter and receiver.
Step-by-step guide for starting the engine.
Procedure for safely stopping the engine.
Solutions for common engine starting and stalling problems.
Troubleshooting steps for when the engine does not run smoothly.
Solutions for problems related to car handling and control.
Guidelines for safe operation, assembly, and maintenance of the RC car.
Precautions for handling and storing flammable glow fuel safely.
Safety warnings related to the engine, hot parts, and rotating components.
First aid procedures in case of fuel exposure or ingestion.