tint-LED-PANEL
68
INSTRUCTION MANUAL
5. Hold down the group button again until the selected tint product
starts to blink again.
The group display for group 1 will also light up.
6. Using the group button, select (if necessary) the group to which you
would like to add the tint product while the feedback display still is
blinking red/green.
The selected bulb will be assigned to default group (=group 1) if group
button is not pressed at all. After approx. 10 seconds, the tint product
will be added to the selected group and the feedback display will stop
blinking. Wait this long, not pressing any buttons during this time.
The procedure will then end and you can use the extended group as
normal.
Reset
Reset to 100% light
The tint light bulbs and luminaires can be easily reset by light switch to
the basic setting of warm white and 100% brightness. This may be ne-
cessary, for example, if you have dimmed the tint products before and the
remote control‘s batteries are empty. This feature may also be used in the
normal case if you do not have the tint remote control on hand.
1. Use the light switch to switch the tint product off and on again 3 times
(interval of 3 seconds).
2. The tint product will now start in its basic setting, warm white, 100%.
Resetting the tint product
Resetting the tint LED Panel is only required in exceptional cases, such
as when the remote control has had to be reset or when you want to
To Next Page
Loading...
Need help?
General
