Multi-Mover M18 - Design Specifications

___________________________________
_______________________________________________________
_______________________________________________________________________________________
Multi-Mover.eu
2
2.DESIGN / SPECIFICATIONS
Primary voltage : 230 Vac - 50/60 Hz - 1-phase
Secondary nominal voltage : 24 Vdc
Secondary maximum voltage : 35 Vdc
Secondary current : max. 5 A for 2410SR10
Battery type : Gel / AGM
Battery capacity :
Min. Max.
(in order to charge 80%
capacity within 8 hours)
LA-185 30Ah 50 Ah
Protective devices : - protected against reversed polarity
- protected against overvoltage
- protected against high temperatures
Input power : 180 W
Efficiency : min. 80% (at full load)
Ambient temperature : 0 °C to +40 °C
Dimensions cabinet : Height 90 x Width 110 x Depth 220 mm
Safety class : II
Overall weight : 1,0 kg
Transport and storage
Ambient temperature storage : -15°C … +50°C.
Relative air humidity max. : 95 % (non condensing)
3. General Warnings
1
Before each use of the battery charger the instructions set out below must be carefully read and
abided by
2
The failure to follow these Instructions and/or errors in installing or using the battery charger,
could lead to endangering the operator and/or damaging the device, voiding the manufacturers
guarantee.
3
The battery charger cannot be used as a component in systems which provide life support and/or
medical devices, without explicit written authorization from Multi-Mover Europe BV,
4
The battery charger must not be used by persons with reduced physical, sensory and mental
capabilities or with lack of experience and/or knowledge, unless they are properly supervised and
instructed by a person responsible for their safety,