___________________________________
_______________________________________________________
_______________________________________________________________________________________
Multi-Mover.eu
5
28
We recommend fitting a fuse between battery charger and battery. Which is standard on the Multi-
Movers. The fuse must be installed along the connection to the positive terminal of the battery. The
rating of the fuse must be proportionate to the nominal output current of the battery charger, the
diameter of cable used and the environment in which it is to be installed.
29
We recommend unplugging it from the mains supply before connecting and disconnecting
batteries.
30
During normal operation of the battery charger. The external surface may become hot and may
remain so for a certain period of time after it has been switched off.
31
The battery charger needs no special maintenance, only regular cleaning procedures. To be
carried out according to the type of working environment. Cleaning procedures should only be
carried out on the external surface of the battery charger. Before starting any cleaning procedures,
the mains supply cable and battery cables must be unplugged. Do NOT use water and/or detergents
in general and/or pressure washers of any kind when carrying out cleaning.
LACK OF USE
32
If safe operation of the battery charger can no longer be ensured, stop the device and
ensure that it cannot be put back into operation.
33
The specifications set out in this manual are subject to change without any notice. This
publication replaces any previously supplied information.
To Next Page
Loading...
