Need help?Do you have a question about the Multiplex EasyGlider PRO and is the answer not in the manual?
General| Wingspan | 1800 mm |
|---|---|
| Weight | 1100 g |
| Material | Elapor foam |
| Recommended Age | 14+ |
| Fuselage length | 1130 mm |
| Wing area | 41.6 dm² |
| Wing loading | 26.4 g/dm² |
| Skill Level | Intermediate |
| Control | Elevator, Rudder, Aileron |
| Length | 1130 mm |
| Motor | Brushless 2830-1100 kV |
| Battery | 3S LiPo 2200 mAh |
Screw the motor to the motor mount, ensuring free rotation and proper cable routing.
Fit the propeller driver and hexagon driver nut onto the motor shaft.
Attach folding propeller blades to the blade holder using supplied screws and nuts.
Mount the blade holder assembly onto the propeller driver and secure it.
Attach the spinner to the propeller driver using the central screw.
Connect the three motor wires to the speed controller wires; order is unimportant.
Connect the UNI connector from the speed controller to your receiver.
Switch on the transmitter and ensure the throttle control is in the OFF position.
Connect the flight battery to the speed controller.
Verify motor spins clockwise; swap two motor wires if rotation is incorrect.
Set the motor brake on the speed controller to ON as per its instructions.
To Next Page
