Need help?Do you have a question about the Multiplex Funray and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Wing loading | 38 g/dm² |
| Material | Elapor |
| Recommended Battery | 3S LiPo, 2200mAh |
| Servos | 2x Nano-S, 2x Tiny-S |
Details on the intended use of the model in the hobby sector and required accessories.
Explanation of inherent risks even when operating the model according to regulations.
Information on model kits, handling precautions, and warnings about misuse.
Specific instructions and recommendations for using Zacki ELAPOR® adhesive.
List of remote control elements, other accessories, and recommended equipment.
Detailed specifications including wingspan, weight, wing area, and RC functions.
Steps 1-13 cover initial fuselage parts, clips, controller, and servo setup.
Steps 14-21 detail rudder hinges, fuselage reinforcement, and motor fitting.
Steps 22-29 cover elevator unit assembly, linkages, and rod connections.
Steps 30-40 involve wing leading edges, reinforcement, and servo preparation.
Steps 41-50 cover cable routing, canopy fitting, and final assembly procedures.
Steps 51-54 guide decal application, landing skids, battery mounting, and CG.
Step 55 provides guidelines for setting control surface deflections.
Steps 56-58 cover pre-flight checks, maiden flight advice, and thermal flying.
Steps 59-63 discuss slope flying, aero-towing, electric flying, and general safety.
To Next Page
