To Next PageTo Next Page
Need help?Do you have a question about the Multiplex FunCub NG 1-01526 and is the answer not in the manual?
General| Wingspan | 1400 mm |
|---|---|
| Flight time | 10-15 minutes |
| Material | Elapor |
| RC functions | Aileron, Elevator, Rudder, Flaps |
| Battery | 3S LiPo, 2200 mAh |
Assemble the tailplane to the fuselage, ensuring correct alignment and adhesion.
Attach the vertical tail, ensuring it's at a right angle and apply decals.
Assemble the main undercarriage, wheels, and tail undercarriage with specific parts.
Connect pushrods to servos and rudders, ensuring neutral position.
Glue the aero-tow release into the wing and connect the servo and pushrod.
Place the receiver behind the undercarriage mount, connect servos, and secure.
Connect wings to fuselage, tighten screws, and adjust strut fork heads.
Set rudder, aileron, and elevator deflections, ensuring servos are not overloaded.
Mount the propeller, spacer, spinner holder, and spinner, ensuring it is tight and balanced.
Perform preflight checks on controls, propeller, and set the center of gravity.
