Multiplex FunCub NG 1-01526 - Accessories and Tools

12
Scope of delivery FunCub NG RR
Accessories and tools
Required accessories Required tool
Optional accessories
• 1 Elapor
®
model (almost fully assembled)
• 1 drive motor ROXXY BL C35-42-930 # 1-01484
• 1 controller ROXXY BL Control 740 S-BEC # 1-01317
• 4 servo Hitec HS-55+ # 1-01205
• 2 servo Hitec HS-65HB # 112065
• 1 propeller 13x4 # 733114
Specications
Wingspan 1410 mm
Overall length 1050 mm
Flight weight 1380 g
Wing area 39.9 dm²
Wing loading 34.6 g/dm²
RC functions Aileron, elevator, rudder, motor,
landing aps, optional aero-tow release
• 2 x Zacki2 ELAPOR
®
20g # 1-01291
• 1x Zackivator - activator for Zacki and CA adhesive # 1-01032
• 1 x receiver RX-7-DR light M-LINK 2.4 GHz # 55810
• 1 x ROXXY EVO LiPo 3 - 2600M 40C with BID chip # 316656
When using aero-tow release, we recommend:
• 1 x receiver RX-9-DR M-LINK 2.4 GHz
(instead of RX-7)
# 55812
• 1 x medium-sized slotted screwdriver
• 1 x small at nose pliers
• 1 x hex wrench 1.5 mm (included)
• 1 x 10 mm open-ended wrench or socket wrench
• 1 x sheet of 240-320 grit sandpaper
• 1 x cockpit SX telemetry set # 25161
• 1 x oat kit FunCub # 1-01539
• 1 x oat kit FunCub NG blue # 1-01585
• 1 x servo 55+ for aero-tow release # 1-01205
• 1 x POWER-MULTIlight # 73030
• 1 x LiPo checker # 118380
• 1 x Hitec multi charger X1 red # 114131
• 1 x Wingstabi 7 channel # 55010
• 1 x Wingstabi RX 7 DR # 55012
• 1 x propeller balancer # 332355
EN