Need help?Do you have a question about the Multiplex EasyGlider and is the answer not in the manual?
Prepare and install elevator, rudder, and aerial snakes into fuselage shells.
Install towhook, servos, canopy latch, and rudder hinge, then join fuselage.
Attach control horns to rudder/elevator and glue tailplane to fuselage.
Install aileron horns, servos, pushrods, and servo leads, and glue wing joiner covers.
Install the receiver, battery, and switch harness in the model.
Steps and checks before the initial flight, including range checks.
Overview of flying methods like slope soaring, aero-towing, and electric flight.
Understand aircraft axes, wing section, CG, and control surface functions.
Adjust control surface throws for proper model response.
Explanation of transmitter stick functions and control assignments.
To Next Page
General