12
Accessories and tools
FunJet 2 FunJet ULTRA 2
Wingspan: 783 mm 783 mm
Fuselage length: 750 mm 750 mm
Flight weight: Approx. 600 g Approx. 875 g
Wing area: Approx. 14.5 dm² Approx. 14.5 dm²
Wing loading: 43 g/dm² 60 g/dm²
RC functions: Aileron, elevator (Delta Mix required) and motor control
Specications
Power recommendation
• WINGSTABI 7-channel # 5 5010
• WINGSTABI RX-7-DR M-LINK # 5 5012
• Servo Nano Pro KARBONITE # 6 5118
• Servo HS-65MG # 11 2066
• Servo HS-5065MG # 11 3065
• Servo HS-5070MH # 11 3070
• Receiver RX-7-DR M-LINK 2.4 GHz # 5 5811
• Telemetry controller ROXXY Smart Control 70 MSB # 31 8579
• GPS V2 sensor for M-LINK receiver # 8 5417
• Flight recorder # 8 5420
• Propeller balancer # 33 2355
• Power kit FunJet 2 # 1-00961
Contents:
Motor: ROXXY BL Outrunner C35-36-2270kv # 1-00997
Controller: ROXXY BL Control 755 S-BEC # 1-01010
Propeller: 5.5"x4.5" # 33 1419
Driver with spinner, for Ø 3.2 mm shafts,
6 mm propeller hole
# 33 2308
• Battery: ROXXY EVO Lipo 3-2600M 40C # 31 6656
• Power kit FunJet ULTRA 2 # 1-00962
Contents:
Motor: ROXXY BL Outrunner C35-36-1960kv # 1-00996
Controller: ROXXY BL Control 755 S-BEC # 1-01010
Propeller: 6"x5.5" # 73 3195
Driver with spinner, for Ø 4 mm shafts,
8 mm propeller hole
# 33 2329
• Battery: ROXXY EVO Lipo 4-2600M 40C # 1-01025
• 2 x servo Hitec HS-65HB # 11 2065
• 1x receiver RX-6-DR light M-LINK 2.4 GHz # 5 5809
• 2 x extension cable 15 cm # 8 5019
• 1x Zacki ELAPOR
®
20 g # 85 2727
• 1x plug fuses # 1-00137
The following accessories are required to assemble the model
Required tool
Optional accessories
• Small cross-tip screwdriver
• Hex wrench 1.5
• Punch Ø 4-5 mm or a small round le
• 10 mm open-ended wrench
• Possibly accelerator spray for CA adhesive
• Hot glue gun
EN
To Next Page
