MULTISPAN PC-1006D - Working; Counter Operation and Relay Behavior; Power Failure and Reset Procedures

www.multispanindia.comPage-3
PC-1006D,2006
Pulse
UP/Down
U P
P U L S
Fast,Slow,Medium
Exp:100Pulse=1Count
Scale=1.00000
Exponent=-2
F a S T
PresskeytoSave&Exit.
Working
1).Whenpulsecomesfromsensor,DisplayindicatesincreaseʻCOUNTʼ.
2).ForManualMode,settime=00.0sec.andforAutoResetMode,settime=00.1to99.9sec.
3).Whenprocessvalue=setpointvalue,Relayenergise.RelayremainsONforAutoReset
TimeRelayturnsoffaftercompletionoftime.Iftimeissetat00.0sec.thenrelayremains
ONuntilkeyispressed.
4).IfthereisapowerfailurethelastreadingisstoredinthememoryandCounterstartsresume
countingfromthelaststoredvalue,whenpowerON.
5).TorestartCountingortoResetpresskey.Upperdisplaywillshow000000andthe
countingwillrestart.
6).TheSensorgivepulsetocountereverytimethemetalontherollerissensed.
7).IftheparameterDOWNisset.TheSETpointswillbeCOUNTtowards0.
And0willbeRELAYON.

RESET
RESET
9.99to99.9,999
0 .0 0
C O U N T
Presskey
Presskey
Presskey
Presskey
Presskeyto
changeparameter
Presskeyto
changeparameter
Presskeyto
changeparameter