Installation
9
Installation in Windows 95
Only certain versions of Windows 95 offer support for USB
peripherals. If you are unsure if your Win95 system supports USB, a
free USB evaluation utility is available from the Shopping Bag page
at http://www.usb.org. Just download the utility (287K) and run the
.exe application. It will determine if you have USB support.
Note: Dialog boxes for the Windows 95 installation are not shown
because they may vary depending on the version of Windows 95
being used.
If you would like to install your MT5634MU in Windows 95, perform
the following steps.
1. Insert the MT5634MU Installation CD into your CD drive.
2. If you have not already done so, connect the MT5634MU to
your computer’s USB port and connect the telephone line to
your MT5634MU and a telephone wall jack.
3. Windows will detect that the new modem is present and launch
the Update Device Driver Wizard dialog box. Click Next to
proceed with the installation.
4. The Update Device Driver Wizard dialog box appears
indicating that Windows has searched for the driver on X:\ (“X”
represents CD drive) and, when identified, displays the driver
name for verification. Verify that the correct name is displayed
and click Finish to install the driver.
5. Windows prompts you to insert a CD. Since you have already
inserted the CD, simply click OK to continue.
6. The Copy Files ... dialog box is displayed. In the Copy files
from field, choose X:\ from the drop-down list and click OK. (X
denotes the drive letter of your CD drive.)
7. When driver installation is finished, a completion message will
appear, the TR LED on your modem will light, and the wizard
will exit. At this time your installation is complete. Remove the
CD from the computer.
After installation is complete, you should test the operation of your
new MT5634MU by registering it. Key in the URL given below and
follow the on-line instructions:
http://www.multitech.com/register
To Next Page
Loading...
