MEMORY
Your pager automatically stores up to four messages.
To recall messages from memory press the OCR button
twice from a blank display. The most recent message is
displayed prefixed by ‘M1’ or the time at which it was
received. When the memory is full a new message
erases the oldest one. Each call is designated new
status when first received. This is removed by
cancelling alert sequence (press the OCR button during
the alert period) or by accessing the call from memory.
“X New Messages” on display shows the number of
messages with ‘new’ status. This prompts your attention
to unacknowledged calls.
Successive presses of the OCR button recall other
messages from memory on a last-in first-out basis.
(Not applicable to 530T variants)
To Next Page
Loading...
