MUNBYN ITPP130 - Printer Overview; Set Up The Printer

1.2 Printer Overview 2.1 Quick printer connection
2.2 Label setup
Load no less than 4
consecutive labels into the
printer.
After the paper is stable,
press and hold feeder
button, until you hear a
beep.
Then, the printer will
automatically label
identification.
Recommended:
Watch the short setup video at:
www.bit.ly/unboxing130
02
Set Up The Printer
Automatic label
identification:
Please follow the sequence of the above picture to
operate.
Feeder button
and status light
DC power
connector
USB
connector
Power
switch
Cover button
Cover
button
0302