ONLY SET THE TIME OF TIMER
OFF
Push button TIMER OFF, the wire
controller display SETTING, the icons of
HOUR and OFF display on the timer
setting area. The wire controller enters
into the setting of timer off.
Push button TIMER OFF again, and
then adjust the time of timer off as your
desired.
Continuously push the button, the time
of timer will increase 0.5 hours per time.
After the time of timer reaches to 10
hours, the time will increase 1 hour each
time.
0.5 seconds later, after finishing the
adjustment, the wire conditioner sends
After the time of timer reaches to 10
hours, the time will increase 1hour each
time.
0.5 seconds later, after finishing the
adjustment, the wire conditioner sends
the information of time on, the timer on
setting is completed.
8. TECHNIQUE CERTIFI
CATION AND REQUIRE
MENT
EMC and EMR should conform to the
CE certification.
Remark: the time of TIMER ON is the
relative time; it is relative to the
standard time of operating wire control ler. If having setting the TIMER ON or
TIMER OFF, then the clock can not be adjusted.
the information of timer off, the timer off
setting is completed.
SET THE TIME OF TIMER ON AND
TIMER OFF SIMULTANEOUSLY
Refer to step 1 and step 2 of TIMER
ON to set the TIMER ON.
Refer to step 1 and step 2 of TIMER
OFF to set the TIMER OFF.
When set the TIMER ON and TIMER
OFF simultaneously, if the set times of
TIMER ON and TIMER OFF are all over
10 hours, then TIMER OFF is always
later 1 hour than TIMER ON.
0.5 seconds later, after finishing the adjustment, the wire conditioner sends
the information of timer onf, the timer off
and timer on setting are completed.
Alter the timer
To alter the time of TIMER ON of
TIMER OFF, push the timer button to
confirm once more. Adjust the time of
TIMER ON and TIMER OFF as 0.0 to
cancel the TIMER ON of TIMER OFF.
4
1
1
2
2
3
3
4
4
To Next Page
Loading...