6. NAME AND FUNCTIONS OF BUTTONS ON WIRE
CONTROLLER
ON / OFF button
Adjust button
Adjust button
TIMER ON
TIMER OFF
TEMP
REPLACE LOCK
COOL
HEATING
MODE
FAN SPEED
CLOCK
CONFIRM
ECONOMICAL
SWING
Economical button
Swing button
COOL ONLY/COOL and
Heating selection button
Lock button
Time
r
on button
Time
r
off button
Clock button
confirm button
replace nutton
Mode selection button
Fan
spee
d selection
Reset button
RESET
OK
Ok button
Mode selection button:
It is used to select mode, push the
button one time, then the operation
modes will change in turn as follows:
AUTO→COOLING→DEHUMIDIFY→
HEATING→FAN
Remarks: no heating mode if wire
controller is set as the cool only.
Timer on button :
Push the button to set TIMER ON,
each time you push the button the time
moves forward by o.5 hours. When the
set time is over 10 hours, each time
you push the button the time moves
forward by 1 hour. If want to cancel the
TIMER ON, then adjust the time of
TIMER ON as 0.0.
Timer off button:
Push the button to set TIMER OFF,
each time you push the button the time
moves forward by o.5 hours. When the
set time is over 10 hours, each time
you push the button the time moves
forward by 1 hour. If want to cancel the
TIMER OFF, then adjust the time of
TIMER OFF as 0.0.
CLOCK button:
Normally display the clock set currently
(display 12:00 for the first electrifying or
resetting). When push the button for 4
seconds, the hour part on the clock
display flashes every 0.5 seconds, then
push button and to adjust hour; push
the button CLOCK again, the minute part
flashes every 0.5 seconds, then push
and button to adjust minute. When set
clock or alter clock setting, must push the
confirm button to complete the setting.
1
2
3
4
To Next Page
Loading...