To Next PageTo Next Page
Need help?Do you have a question about the Murphy M2582 Series and is the answer not in the manual?
General| Brand | Murphy |
|---|---|
| Series | M2582 |
| Category | Control Unit |
| Enclosure Rating | IP67 |
| Number of Analog Inputs | 4 |
| Number of Relay Outputs | 4 |
| Operating Temperature Range | -40°C to +85°C |
| Communication Protocol | J1939 |
| Manufacturer | Enovation Controls |
Fuel shut-off valves for engine ignition or battery systems.
Pneumatic fuel shut-off valves for pressure control.
Normally energized fuel shut-off valve with manual open.
Adapter for CD ignition systems to reliably trip fuel valve.
Resistor for Capacitor Discharge Ignitions with Magnetic Switch Adapter.
Package for using fuel shut-off valve with dual Magneto Ignition systems.
Pressure drop versus flow rate for M2582 series valves.
Pressure drop versus flow rate for M5081/M5180 series valves.
Explanation of valve open/closed positions and vent function.
Diagram identifying key components of the fuel shut-off valve.
Dimensional drawing for the M2582 fuel shut-off valve.
Dimensional drawing for the M2582-P pneumatic valve.
Dimensional drawing for the M5180-P pneumatic valve.
Dimensional drawing for magnetic switch adapter components.
Dimensional drawing for M5081 and M5081FS valves.
Dimensional drawing for the M5081-3 flanged valve option.
Step-by-step guide for plumbing the fuel shut-off valve.
Specific installation steps for pneumatic M2582-P/M5180-P valves.
Internal wiring details for the M2582 series valve.
Internal wiring details for the M5081 series valve.
Wiring for specific M2582-C-LS and M5081-C-LS models.
Internal wiring details for the M5081FS valve.
Wiring instructions for magnetic switch adapters with CD ignitions.
Wiring diagram for M5081-C with CD ignition systems.
Wiring diagram for M5081-B with battery ignition systems.
Wiring diagram for M5081-A with magneto ignition systems.
Wiring diagram for M5081FS normally energized models.
Wiring M2582-C to LCDT-PS-CD (positive/negative ground).
Wiring M5081-C to LCDT-PS-CD (positive/negative ground).
Wiring M2582-C to MARK IV-N annunciator.
Wiring M5081-C to MARK IV-N annunciator.
Wiring M5081FS to MARK IV-12/24 annunciator.
Wiring M5081-B to MARK IV-12/24 annunciator.
Wiring M5081FS to MARK III-12/24 annunciator.
Wiring M5081-C to MARK III-N annunciator.
Wiring M5081-C to TTDJ-IGN-(T).
Wiring M2582-C to TTDJ-IGN-(T).
Wiring M5081-B to TTDJ-DC-(T) with relays.
Wiring M2582-B to TTDJ-DC-(T) with relays.
Wiring M5081FS to TTDJ-DC-(T) with relays.
Wiring M2582-C to CD ignition via magnetic switch adapter.
Wiring M5081-C to CD ignition via magnetic switch adapter.
Details on valve body construction, seat material, and pressure ratings.
Information on coil ratings, voltage, and CSA/laboratory approvals.
Part numbers for various components of the fuel shut-off valves.
Details on the limited warranty for FW Murphy products.
