EasyManua.ls Logo

murprotec CTA 500 - In Case of Problems; Power Outage; Warranty

murprotec CTA 500
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
49
ENGLISH
In the event of a general power outage, the device is reinitialized at the last position recorded in automatic or manual mode
when the circuits are reconnected, except in the case of temporary mode (the device will go into automatic or manual mode
depending on the settings before put in temporary mode).
After a storm or surge in the circuits, the AHU may not start. In such a case, switch off the power supply of the device or the
general power supply for a least one minute than switch it on again.
8. POWER OUTAGE
Do not hesitate to contact your installer.
9. IN CASE OF PROBLEMS
The recourse in warranty must be with Murprotect without fail. Please refer to the conditions of the contract.
The warranty does not apply in the following cases:
• Damage caused by natural phenomena (lightning, flooding, etc.) or from water leaks;
• Shocks, abnormal variations in current voltage, non-compliance with the conditions of use;
• Adaptation of the original installation;
• Repair or intervention other than a change of filter;
• The use of filters other than those provided for this device;
• Adaptation of the filter;
• Non-compliance with the instructions for use;
10. WARRANTY

Table of Contents

Related product manuals