OPERATION
21
F–030728L
HOW TO CHANGE THE MULCHER PLATE
WARNING: To prevent the engine from starting, dis-
connect the wire from the spark plug. Make sure the
blade rotation control is in the DISENGAGE position.
The mulcher plate lets you mulch the grass for a clean, fine cut. To
discharge the grass out the side or into a grass bagger, remove the
mulcher plate as follows.
How To Remove The Mulcher Plate
1. Raise the deflector. Remove the two wingnuts B and two car-
riage bolts A (Figure 11).
2. Lift the mulcher plate away from the mower housing.
3. Attach wingnuts B and carriage bolts A to the mulcher plate
for future use.
How To Install The Mulcher Plate
1. Raise the deflector. Slide the front of the mulcher plate under
the deflector bracket (Figure 11). If necessary, remove grass
from flange.
2. Fasten the mulcher plate with two wingnuts and two carriage
bolts.
Figure 11
B
B
A
Deflector
Mulcher Plate
Deflector Bracket
To Next Page
Loading...
