21
OPERATINGINSTRUCTIONS
Switching Off the Engine
Emergency Stop procedure
• If it becomes necessary to stop the machine immediately. Let go of the throttle lever and
move the stop switch to 'OFF'.
Practical tips
• Practice all operating techniques with the engine switched off before you start to use the
machine.
DO NOT use steel wire or plastic-coated steel wire of any kind with
your string head. Serious operator injury can result.
Periodically remove weed wrap to prevent overheating the drive shaft.
Weed wrap occurs when strands of weed become entangled around
the shaft beneath the debris shield. This condition prevents the shaft
from being properly cooled.
• Stop engine – Remove spark plug H.T. lead from spark plug.
• Remove Weed/Grass wrapped around Head/Shaft.
• When properly equipped with a guard and cutting head, your unit will trim unsightly
weeds and tall grass in those hard-to-reach areas – along fences, walls, foundations
and around trees. It can also be used for scalping to remove vegetation down to the
ground for easier preparation of a garden or to clean out a particular area.
Trimming / Mowing
• Swing trimmer with a sickle-like motion from side to side.
Do not tilt the cutting head during the procedure. Test
area to be trimmed for proper cutting height. Keep string
head at same level for even depth of cut.
Trimming Procedures
Trimming around foundations, brick or
stone walls, curves, etc will result in
above normal string wear.
Fence / Foundation Trimming
• Approach trimming around chain link fences, picket fences, rock walls and foundations
slowly to cut close without whipping string against the barrier. If the string comes
in contact with rock, brick walls, or foundations, it will break or fray. If string snags
fencing, it will snap off.
To Next Page
Loading...
