5
Quick Start Guide
NOTE: IF STARTING IS A PROBLEM GO TO PAGE (19) FOR A MORE DETAILED
VERSION OF THE STARTING PROCEDURE
QUICKSTART
1
2
3
• Place the trimmer on a hard, level surface.
• Press the PRIMER 10 times.
• Set STOP switch to the “ON” position
(slide it backwards towards the engine).
1 – Get ready…
• Secure the throttle lever as follows:
– Press and hold the throttle release (1)
– Press and hold the throttle lever (2)
– Press the throttle lock (3)
– Now let go of the throttle release
and throttle lever
• Set the choke lever to COLD
2 – Set
• Pull the starter cord until you feel it resist.
Then tug sharply on the starter cord 2 or 3 times.
*
The engine may start or run for a short period set
on cold. Choke can be set to hot while the engine is
running.
• Now, set the choke lever to the HOT position.
• Tug sharply on the starter cord as before.
2 or 3 pulls should start your trimmer.
3 – Go!
To Next Page
Loading...
