Mutable Instruments Ripples - User Manual

Ripples
Liquid filter
Installation
Ripples requires a -12V /
+12V power supply (2x5 pin
connector). The ribbon cable
connector must be aligned
so that the red stripe of the
ribbon cable (-12V) is on the
same side of the module’s
power header as the “Red
stripe” marking on the
board.
The power consumption is:
+12V: 35 mA; -12V: 35 mA
Calibration
Adjust the trimmer on the
back of the module so that
the tone emitted by the filter
(when it self-oscillates)
tracks a 1V/oct CV sent to
the FREQ input.
Online manual
and help
The full manual can be
found online at
mutable-instruments.net/
modules/ripples/manual
For help and discussions,
head to
mutable-instruments.net/
forum/

Summary

Installation and Power

Calibration Procedure

Online Manual and Support

Front Panel Overview

Controls

Details on Resonance, Frequency cutoff, and FM Attenuverter settings.

Inputs and Outputs

Description of CV inputs, Audio input, VC gain control, and filter outputs.

Mutable Instruments Ripples Specifications