19
EN
· Press the fold-lock (a2) inwards and lift up the top chassis until the
chassis clicks into place and pull the push bar up until it clicks into
place. (b)
· Press on the pram to lock the rear axle.
· Before each use of the pram, check that the chassis is correctly and fully
unfolded and locked.
Folding up the chassis (c, d)
· Stand behind the chassis and put on the chassis brake. If necessary,
fold a forward-facing seat forwards or remove a carry cot or adapters
from the attachment points. A rear-facing seat must also be removed.
· Press the push bar height adjustment buttons (c1) and move the
push bar downwards (c2). This movement will unlock the chassis so
that you can fold the chassis in a single movement.
· Push the frame down until the rear axle is unlocked. Pull the frame
towards you to fold the rear axle as well (d).
· The chassis and rear axle lock automatically in the collapsed position.
· Press the push bar click adjuster on both sides and press the push bar
downwards. (a1)
· Tip: you can place the pram upright after it has been folded up.
The wheels
Fitting the rear wheels (e)
· Press the button in the centre of the wheel and slide the rear wheel axle
into the rear wheel housing until a click is heard.
· Pull the wheel to check if it is secure.
Removing the rear wheels (f)
· Press the button in the centre of the wheel and remove the wheel from
the chassis.
Fitting the front wheels (g1)
· Slide the front wheel axle up into the front wheel housing until a click is
heard.
· Pull the wheel to check if it is secure.
Disassemble the front wheels (g)
· Press the button on the front side of the front wheel and pull the wheel
out of the front wheel housing.
The swivelling wheels (h1)
· Turn the knob above the front wheel on both sides to the rear to block
To Next Page
Loading...
