Mutsy NIO - Place the Maxi-Cosi car seat on the adapters; Remove the Maxi-Cosi car seat from the adapters; Remove the Maxi-Cosi adapters from the frame; BeSafe; Kiddy; Cybex car seats

25
EN
Place the Maxi-Cosi car seat on the adapters
· Orientate the Maxi-Cosi car seat such that it is directed rearwards on
the chassis.
· Hold the Maxi-Cosi car seat with the central hinge points of the support
bar directly above the adapters.
· Lower the Maxi-Cosi car seat and press solidly into the adapters until
you hear a click.
· Check that the Maxi-Cosi car seat has been placed horizontally and has
been attached properly by trying to lift it from the chassis.
Remove the Maxi-Cosi car seat from the adapters
· Operate the unlocking system of the Maxi-Cosi car seat. Lift the Maxi-
Cosi car seat straight up from the chassis.
Remove the Maxi-Cosi adapters from the frame
· Slide the unlocking button on the frame attachment points upwards
until you hear a click. The adapter can now be taken o the frame.
BeSafe / Kiddy / Cybex car seats
· Maxi-Cosi car seat adapters are suitable for use with the following car
seats:
· BeSafe: iZi Go, iZi Go Modular
· Kiddy: Evolution Pro, Evolution Pro 2, Evo-luna i-size
· Cybex: Aton, Aton 4, Aton Q
· Always read the instructions for use in your car seat manual carefully
before you start using the car seat.
· Ensure that the frame is fully unfolded and the brake applied during all
of the actions indicated below.
· For tting and removing adapters: please refer to Maxi-Cosi adapters
· For tting and removing car seats to / from adapters, please refer to the
instructions in your car seat manual.