7
USE OF JUICER
This appliance is designed for domestic use, so to avoid overheating the
engine and prolong its life, do NOT use the juicer continuously for more than 1
minute followed. Pause for about 1 minute.
If you notice while using the pulp container centrifuge or filter are too full of
waste, turn off the juicer, unplug it from the mains and proceed to clean them
before continuing to use the operation.
START UP
• Make sure all the components of the juicer are perfectly matched and that
the shutter is properly seated in the top cover.
• Plug the juicer to the main power.
• Slide down the outlet for pouring juice and put the jug for juice.
• Remove the pushing bar.
• Previously he must have cut food so that they can enter the filler neck.
• By the gear selector choose the right speed and wait a few seconds for the
engine revolutions to acquire adequate.
• Place the ingredients for the filling mouth and insert the pusher gently
introduced to the food is processed.
Note: Never use your fingers or other tool to push food through the filler
neck, use only the supplied pusher.
• After the extraction of juice from foods, remove carafe for juice and lift out
for pouring the juice, this will prevent other accumulated in the drip juicer.
CLEANING
• Before to cleaning the juicer unplug it from the main power.
• Do not immerse the motor assembly base or in water or under running
water.
• The container for the pulp, juice jug and spin filter can be washed in a
dishwasher. The other accessories should be washed with warm water and
detergent.
• The surface of the base or juicer motor assembly can be cleaned with a
damp cloth. Do not use alcohol or abrasives.
Very important:
The spin filter contains very sharp edges so during handling or cleaning the
most extreme precautions to avoid personal injury.
STORAGE
To storage her juicer, make sure it is clean and dry. Store your juicer in a dry,
dust-free, within their own packing or cover it with a protective plastic bag,
paper, etc.
To Next Page
Loading...
