MYERS MP Series User Manual (English)

Other manuals for MYERS MP Series

Questions and Answers:

fmcmahonAug 17, 2025

What to do if there is no output available from MYERS Camera Accessories PTS?

D
Daniel MckenzieAug 17, 2025
If there's no output from your MYERS Camera Accessories PTS, here's what you can check: * Ensure the upstream utility circuit breaker or fuse is closed. * Verify utility AC power is available, using an AC voltmeter and contacting the Utility Company if needed. * Correct any wiring errors at the PTS terminal block. * If 120 VAC is present at “L IN” and NEUTRAL at the PTS terminal block, the PTS may be faulty and require replacement.

josephthomasAug 20, 2025

Why won’t MYERS Camera Accessories PTS allow transfer to Battery mode?

C
Caitlin MooreAug 20, 2025
If your MYERS Camera Accessories PTS won’t switch to battery mode, consider these potential causes: 1. The MP2000E output power might not be correctly connected to the PTS. Ensure the “BBS OUT” cord from the PTS is properly connected to the AC OUTPUT Quick Connect socket or terminal block on the MP2000E. 2. The “BBS INPUT” circuit breaker at the PTS could be open. Reset the breaker and clear any faults. 3. The black and red control wires from the PTS may not be connected to the MP2000E. Check the connection at the MP2000E. 4. The PTS itself might be faulty, requiring replacement.

Brand

Model

MP Series