What to do if MyGenie Vacuum Cleaner hand vacuum brushes will not pick-up?
If the brushes on your MyGenie Vacuum Cleaner hand vacuum are not picking up, it's possible that the dust cup is full. Empty and clean the dust cup container to resolve this issue.
Why MyGenie Vacuum Cleaner hand vacuum will not pick up or suction power is weak?
If your MyGenie Vacuum Cleaner's hand vacuum isn't picking up debris or the suction is weak, it could be due to a full dust cup or a dust cup filter that needs cleaning. To resolve this, empty the dust cup. Also, remove the dust cup filter and check the air duct for any obstructions, removing them as necessary.
What to do if dust is escaping from MyGenie Vacuum Cleaner hand vacuum?
If dust is escaping from your MyGenie Vacuum Cleaner hand vacuum, it may be due to several reasons. First, the dust cup might be full, so empty it. Second, the dust cup filter may not be installed correctly; review the dust cup filter instructions. Third, there might be a puncture or hole in the dust cup filter, in which case you should replace it.
Step-by-step guide on how to connect the main unit, tube, and brushes.
Instructions on how to connect the adapter and charge the vacuum cleaner.
Procedures for cleaning and replacing the dust cup and filter assembly.
Steps for cleaning the rotating brush, including unlocking and re-securing it.
General| Battery Capacity | 2600 mAh |
|---|---|
| Cleaning Modes | Auto, Spot, Edge, Single Room |
| Type | Robot Vacuum Cleaner |
| Dustbin Capacity | 600 ml |
| Charging Time | 4 hours |
| Features | App Control, Voice Control |
To Next Page
