EasyManua.ls Logo

MYLAN WhisperJECT - Step 7: Remove the Syringe Needle Cap; Pull Off Orange Needle Cap Remover; Collect Fallen Needle Cap Parts; Save Needle Cap Remover for Future Use

Default Icon
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 7 – Remove the Syringe Needle Cap
7B 7C
Turn the Orange Needle Cap Remover
upside down over a table to allow the
pre- lled Syringe Needle Cap to fall out.
Make sure that both the rubber inner
part and the transparent plastic outer
part of the Needle Cap fall out.
TROUBLESHOOTING:
If the needle cap becomes
stuck at the end of the Orange
Needle Cap remover, press
on the needle cap until it
dislodges.
Save the Orange Needle
Cap Remover for future use.
DO NOT dispose of
the Orange Needle Cap
Remover in the trash.
DO NOT
recap the syringe.
7A
Hold the Handle with one hand and the Orange
Needle Cap Remover in your other hand, and
then pull the Orange Needle Cap Remover out of
the Syringe Housing. The grey pre- lled Syringe
Needle Cap will be removed.
DO NOT replace the Orange Needle Cap
Remover onto the Syringe Housing. This may
damage the needle.
DO NOT remove the Orange Needle Cap
Remover until syringe is inserted and device
reassembled.
IMPORTANT: DO NOT press down on Needle
Depth Adjuster as the needle will be exposed and
you could accidentally stick and/or inject yourself.
20 21

Related product manuals