MYLAN WhisperJECT - Step 2: Reset the Autoinjector; Position Syringe Housing; Align and Push Handle; Confirm Reset Status

Position the Handle above
the Syringe Housing with
the open end of the Handle
against the Orange Needle
Cap Remover.
While maintaining one hand
on the Syringe Housing for
stability, push the Handle
down onto the Syringe
Housing until you feel and
hear a “CLICK.” This signals
that the device has locked
into position.
The Viewing Window should
be blank (no green hash mark
or check mark visible).
2B
Place the Syringe Housing on a clean at surface with the
Orange Needle Cap Remover end up.
2A
Step 2 – Reset the Autoinjector
12 13