5. Value is saved automatically if the control knob is left unchanged for 5 seconds
X all three LEDs flash rapidly for 2 seconds, setting is saved.
6. Set the temperature control knob to the desired temperature value.
The setting can be undone. Repeat same procedure as above.
Set AC ELWA the reheating (automatic hot water ensuring)
The AC ELWA can ensure hot water even with no excess energy. Initially, this function is disabled.
The device must be configured as follows:
1. Disconnect power plug
2. Turn temperature control knob to „wrench icon“
3. Connect the mains plug again
Xall 3 LEDs flash (Setup mode is active)
4. Set the temperature control knob to a ° C mark. The setting value corresponds to the temperature of
the table below:
X LEDs red / green (simultaneously) and yellow alternately
5. Value is saved automatically if the control knob is left unchanged for 5 seconds
X all three LEDs flash rapidly for 2 seconds, setting is saved.
6. Set the temperature control knob to the desired temperature value
The setting can be undone. Repeat same procedure as above. Reheating must be activated on PLA
additionally, because PLA controls all connected AC ELWA.
To Next Page
Loading...
Need help?
General