1x: Setup mode 6x: Charge 6x: Charge1x: Setup mode
Normal mode Normal mode
Reheat on Stratification Synchron
Reheat off
2x: Setup time 2x: Setup time 2x: Setup time
0x: time0_:__ 1x: 1 time_:__ 2x: 2 time_:__
3x: Setup time 3x: Setup time
0x: 0 time1 :__ 9x: time1 :__9
4x: Setup time 4x: Setup time
short keystroke
1 s keystroke
1 s keystroke
5 s keystroke
LED on
LED flashes
5 s keystroke
0x: 00 time10: 3x: 45 time10:
1
1x: 15
2
2x: 30
3 4 5 6 7 8
The value for backup heating or stratification / synchronous charge is stored with 1 second keystroke
permanently. Menus are automatically exited without saving if key is not pressed for 30 seconds.
Reheating:
In the first menu item reheating can be enabled. This function is for automatic hot water ensuring. This allows
you to switch off the heating system used normally to heat water. Reheating is useful in non-heating period.
If reheating is on, all connected AC ELWAs which have an adjusted reheating temperature will be activated
from 16:00-23:00, regardless of whether or not excess power is available. The AC ELWAs then heat to each
setpoint.
Time of day
The time setting is relevant to the reheating. The accuracy of time is 15 minutes.
Note: time is not maintained during a power failure!
Stratification and synchronous charge:
x The PLA can control the AC ELWAs with different priorities:
In stratification mode, the AC ELWAs will be driven to their rated power in order (according to their
number, smallest first).
x In synchronous mode all connected ELWAs are controlled with the same power.
To Next Page
Loading...
Need help?
General