Why is my mysoda Soda Makers water not bubbly enough?
If your water isn't as bubbly as you'd like, there are a few potential reasons. It could be that your CO2 cylinder is running low, in which case you should replace it with a new one. Also, ensure that the water you're using is as cold as possible, as CO2 dissolves better in cold water. Finally, check that the CO2 cylinder is screwed in tightly enough to the device.
How to fix CO2 cylinder leak in mysoda Soda Makers?
If the CO2 cylinder leaks after installation, it's likely not screwed in tight enough. Remove the CO2 cylinder and reattach it securely by hand, without using tools, being careful not to overtighten it.
What to do if mysoda Toby water bottle overflows?
If the water bottle overflows during carbonation, it could be due to two reasons: either the bottle is overfilled – in this case, fill the bottle with water up to the fill line indicating the maximum level – or the carbonating button is pressed for too long. Avoid pressing the carbonating button for longer than 1–2 seconds at a time.
What to do if mysoda Toby water bottle can’t be released from the quick lock?
If you're having trouble releasing the water bottle from the quick lock, it might be in the wrong position. Gently pull the water bottle towards yourself until it reaches its fully forward tilt position. Then, release the bottle by turning it one quarter clockwise.
How to attach water bottle to mysoda Toby Soda Makers quick lock?
If the water bottle can’t be attached to the quick lock, it's probably because the quick lock is in the wrong position. Pull the quick lock and nozzle towards yourself, then attach the bottle by turning it one quarter anti-clockwise.
General| Type | Manual |
|---|---|
| Material | Plastic |
| Carbonation Level | Adjustable |
| Bottle Material | BPA-free plastic |
| Color Options | Black, White, Red |
| Warranty | 2 years |
| Bottle Capacity | 1 L |
| Power Source | Manual |
| CO2 Cylinder Compatibility | Standard 60L CO2 cylinders |
To Next Page
